Main > Main Forum

Happ Perfect 360 Wiring

Pages: << < (2/3) > >>

Shieldwolf:

Can anyone give a dummies' guide to connecting to a molex connecton?

Ummon:

Start reading basic electronics and applications.

Czapala:


--- Quote from: DaveStall on November 27, 2008, 10:56:29 pm ---When I wired my P360s, I took the power from one of my motherboard's USB headers.  I just took a USB header cable and cut one end off (obviously not the end that plugs onto the header) and then took the +5V and the ground wires and connected them to a small terminal strip.  Then, run the P360 +5V and ground wires to the terminal strip.

Dave


--- End quote ---

Did you use one USB cable PER joystick?

ie.  Did you use one or 2 USB cables?

Biscuit:


--- Quote from: Czapala on May 01, 2009, 08:43:18 am ---
--- Quote from: DaveStall on November 27, 2008, 10:56:29 pm ---When I wired my P360s, I took the power from one of my motherboard's USB headers.  I just took a USB header cable and cut one end off (obviously not the end that plugs onto the header) and then took the +5V and the ground wires and connected them to a small terminal strip.  Then, run the P360 +5V and ground wires to the terminal strip.

Dave


--- End quote ---

Did you use one USB cable PER joystick?

ie.  Did you use one or 2 USB cables?

--- End quote ---

** BUMP **

I want to know this too.  Can you run more than one joystick to the terminal strip at that point?

genesim:

But what are you using for a keyboard encoder?   Instead of banging your head against the wall, the Ipac has a +5 volt connector already there!  Thats the easiest way I can think of.

Also you can rig it from a power supply if you are using that for your arcade.   

Pages: << < (2/3) > >>

Go to full version