| Main > Main Forum |
| Happ Perfect 360 Wiring |
| << < (2/3) > >> |
| Shieldwolf:
Can anyone give a dummies' guide to connecting to a molex connecton? |
| Ummon:
Start reading basic electronics and applications. |
| Czapala:
--- Quote from: DaveStall on November 27, 2008, 10:56:29 pm ---When I wired my P360s, I took the power from one of my motherboard's USB headers. I just took a USB header cable and cut one end off (obviously not the end that plugs onto the header) and then took the +5V and the ground wires and connected them to a small terminal strip. Then, run the P360 +5V and ground wires to the terminal strip. Dave --- End quote --- Did you use one USB cable PER joystick? ie. Did you use one or 2 USB cables? |
| Biscuit:
--- Quote from: Czapala on May 01, 2009, 08:43:18 am --- --- Quote from: DaveStall on November 27, 2008, 10:56:29 pm ---When I wired my P360s, I took the power from one of my motherboard's USB headers. I just took a USB header cable and cut one end off (obviously not the end that plugs onto the header) and then took the +5V and the ground wires and connected them to a small terminal strip. Then, run the P360 +5V and ground wires to the terminal strip. Dave --- End quote --- Did you use one USB cable PER joystick? ie. Did you use one or 2 USB cables? --- End quote --- ** BUMP ** I want to know this too. Can you run more than one joystick to the terminal strip at that point? |
| genesim:
But what are you using for a keyboard encoder? Instead of banging your head against the wall, the Ipac has a +5 volt connector already there! Thats the easiest way I can think of. Also you can rig it from a power supply if you are using that for your arcade. |
| Navigation |
| Message Index |
| Next page |
| Previous page |