Arcade Collecting > Pinball

system 1 connector housings

<< < (3/3)

Ken Layton:
Updating this old thread. The Gottlieb system 1 connector housings are now at this updated link:

https://www.greatplainselectronics.com/products.asp?cat=77

Remember, some of them are no longer manufactured so stock up.

Fursphere:
I took a small flat head screwdriver that almost fit in the connector housing, then stuck it on the bench grinder and removed material until it fit.  (width wise)

Its worked great so far (I've done two system 80s...  every.gosh.darn.pin on a Black Hole and a Volcano), but its still a total pain.  There is no good way to do this - but you should only have to do it once the entire time you own the thing.   :dunno

Navigation

[0] Message Index

[*] Previous page