| Main > Main Forum |
| Help with Opti-Wiz |
| (1/1) |
| tevans333:
Hi all, I have a driving cab with a 360 degree steering wheel. The wheel has the encoder disk on it but none of the electronics. I believe that the opti-wiz is a good choice as an interface, especially since it is only $15:) But I have a few questions first to make sure I have it all figured out properly. 1) I need 2 opto sensors and a led for use with the encoder wheel? 2) The +5V and gnd on the opti-wiz can be used to power the above? 3) Just wire the 2 opto sensor outputs to the X-axis on the opti-wiz? Thanks for any and all help, Tim |
| mytymaus007:
sounds like it should work 360 wheel to optiwiz is it that simple, where do you get the opto sensors and led for the encoder on the wheel Tim |
| Games001:
Actually, all you need to make a 360* Wheel, as long as it has an encoder wheel mounted, is this: http://forum.arcadecontrols.com/index.php?topic=48855.0 Then use the Opti-Wiz as the controller. +5v and Gnd all run to the same board.. simple. You are basically wiring up a spinner that happens to have a wheel attached. :) |
| Navigation |
| Message Index |