Main > Main Forum
Best way to make pushbutton holes larger?
<< < (2/5) > >>
Kevin Mullins:
Hammer.
fatfingers:

Router.
um3k:
Clamp another piece of scrap over the hole.   Mark the center of the hole on the scrap and use your favorite forstner/spade bit.
Malenko:
wood or metal?

dremel either way, just use either a grinder bit or a sander bit
Xiaou2:

 Dremels stink.   Dont even bother with them.   You would use like 10 little sanding
drums, and it would take about 4hrs to do.

 I 2nd the drill + sanding drum.

 Of course, if you really want fast results,  they sell a special type of drum
made of metal.  It shaves wood like hot butter... and outlast sandpaper drums
by miles.
Navigation
Message Index
Next page
Previous page

Go to full version