Main > Main Forum
Best way to make pushbutton holes larger?
(1/5) > >>
dailygeek:
Hi folks

Just converting my first JAMMA cab and so far so good.  Except that I ordered some new Happ pushbuttons from ultimarc, fully expecting my current buttons to be a standard size but when trying to replace my first one, realised that the diameter of the existing buttons is a couple of mm smaller than Happs.

What is the easiest way of making these holes big enough?  Hole drill bit through lexan and board or perhaps sanding around the edges.  Useless with woodwork which is why i'm converting rather than scratch building ....  ???
clickhea:
iam gonna have to nominate the router for this job.
nuka1195:
drill with a sanding drum.
TheShanMan:
Or file it with a rounded wood file.
DeLuSioNal29:
Dremmel.
Navigation
Message Index
Next page

Go to full version