Main > Main Forum
U360: strange behavior
<< < (2/5) > >>
nuka1195:
http://www.ultimarc.com/ultrastik_inst.html

I don't see where this page says not to calibrate, if it does maybe it should be more pronounced. it's a little misleading to have the windows control panel displayed and not calibrate.

I'm pretty sure we calibrated my friends and have not had any issues.
blind_dado:
Uhm, isn't it pretty clearly stated on the Ultimarc page you listed:

Calibration
The UltraStik 360 requires no calibration. In Analog mode, the setting of "dead zone" in MAME and also any calibration of gamepad joysticks in Windows, will affect the stick, so if you get any strange behaviour, check these are set to default settings.

Ginsu Victim:

--- Quote from: blind_dado on October 24, 2008, 03:10:21 pm ---Uhm, isn't it pretty clearly stated on the Ultimarc page you listed:

Calibration
The UltraStik 360 requires no calibration. In Analog mode, the setting of "dead zone" in MAME and also any calibration of gamepad joysticks in Windows, will affect the stick, so if you get any strange behaviour, check these are set to default settings.



--- End quote ---

Yep. I was well aware of this before I even bought the stick (reading everything first sure helps, nuka). It's right there, plain as day.
nuka1195:
uhm, i see it now way at the bottom, not up where the images were.

if it's a major problem, then a mention up where the image state do not calibrate, may be clearer.

And as i stated we're not having any issues, though i can't swear we calibrated. and i very well may have read it at the time, but a quick look at the page i missed it and stated so. did not say it wasn't i said i didn'y see it.
Ginsu Victim:
Not what I was saying. I was saying you should always read all of the instructions first.
Navigation
Message Index
Next page
Previous page

Go to full version