Main > Reviews
GGG Electric-Ice RGB Ball-Top Prototype Review
Twin-X:
--- Quote from: Ummon on October 11, 2008, 08:14:41 pm ---
There is a thread I think started by Bender on a design for this in particular.
--- End quote ---
Yes we know but the question is can they be used on a U360
csa3d:
The 360s utilize a magnet mounted to the bottom of the shaft. Out of the box, I don't see this working for the 360s. You'll have to figure out how to mount the magnet to the bottom and deal with the extra length of the shaft created by the earphone jack.
Someone (bender?) did this, complete with pics a while ago.
-csa
Ummon:
--- Quote from: Twin-X on October 12, 2008, 06:36:06 am ---
--- Quote from: Ummon on October 11, 2008, 08:14:41 pm ---
There is a thread I think started by Bender on a design for this in particular.
--- End quote ---
Yes we know but the question is can they be used on a U360
--- End quote ---
Obviously, as the point of interface is different, the answer is no.
Franco B:
I want a finders fee for finding the 4-pole sockets :D
Bender manged to get his u360s LED lit by using a two pole plug/socket and extending the PCB standoffs.
Ive been working on a solution for RGB lighting the U360s too:
More info [here]
RandyT:
--- Quote from: Franco B on October 15, 2008, 04:39:40 pm ---I want a finders fee for finding the 4-pole sockets :D
--- End quote ---
Heh, it wasn't the sockets, it was the damn 4-pole right-angle plugs! I'll give you a finders fee if you can locate the Chinese factory they are made in so they don't cost me $4+ a pop ;)
(but thanks for the tip!!! :))
RandyT
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version