| Main > Main Forum |
| Help! Ultra stik 360, trying to change to long handle. |
| (1/5) > >> |
| nickynooch:
Anyone with any advice here... I am trying to change my Ultrastik 360 to the long handle. On the ultimarc site for instructions they just say (http://www.ultimarc.com/ultrastik_inst.html) Long Handles and/or Replacement Spring: There are two possible methods: If your stick is not yet fitted to a panel, remove the 4 screws on the front of the faceplate and remove the swivel assembly. If your stick is already fitted to a panel, remove the PCB by unscrewing the 4 screws. Lift off the magnet assembly from the end of the shaft. Remove the E-Ring. CARE: we advise to avoid spring-loaded parts being lost, place a cloth over the joystick when removing the E-ring. Swap the shafts and/or springs over and re-assemble. I got to the part where it says "remove the e-ring"... what is the e-ring and how do I remove it??!?!?!?!?! Any help or pics would be awesome. I just hope someone else here has done this! Thanks, Nick |
| Turnarcades:
I think it's also known as a C-clip due to it's shape: |
| nickynooch:
Awesome I see that... now here's the question... how do you remove it? I think it needs to go back on after I take it off so I don't wanna break it. |
| Malenko:
--- Quote from: nickynooch on October 04, 2008, 06:28:08 pm ---Awesome I see that... now here's the question... how do you remove it? I think it needs to go back on after I take it off so I don't wanna break it. --- End quote --- shimmy it off with a small flathead screwdriver. and a pair of needle nose pliers. |
| Hoopz:
Carefully pry it off with a jeweler's screwdriver and make sure you don't flip it across the room. Gently pry it so it pops off or slides off onto the counter/work area. |
| Navigation |
| Message Index |
| Next page |