Main > Main Forum
Size of quick disconnect for GGG Micro-leaf
<< < (2/3) > >>
Benevolance:
Sorry, I can only be helpful once per day until I reach third level.
mrclean:
.187 ontop , .250 for the lizard lick picture

as far as the leaf / micro from ggg..


--- Quote ---Smaller control panel footprint. Contacts are vertical and will accept standard .187 Female QD's
--- End quote ---
blind_dado:
Uhm, yeah, that reply made no sense.  The two pictures that I pasted in from Lizard Lick are .110 (top picture) and .187 (bottom picture).  And the quote from GGG solves nothing, as my original point and question was that although the GGG web site SAYS that the micro-leafs accept .187, they clearly are much smaller than the Cherry microswitches, which are .187.  So, it seems that the micro-leafs must be smaller, probably .110.  I was just asking if anyone could verify the actual size of the micro-leafs through experience, not by quoting the web page, which seems wrong.   :banghead:
mrclean:
ask randy directly but worse case if you do buy .187's and should the GGG's be .110 you can always squeeze them with pliers and they would fit perfectly.. It says directly on GGG's site that it works with .187's so i'd just order those QD's
RandyT:

The terminals on the MicroLeaf switches are indeed .110"  The description at the site addresses the use of .187" connectors with them (and they do work, at least the ones I have tried) primarily because many will be wanting to replace existing switches.  It is important to note that it is not necessary to replace the existing connectors to do so.

RandyT
Navigation
Message Index
Next page
Previous page

Go to full version