Main > Main Forum
U-track movement?
(1/1)
pupu:
I have my trackball set up but I cant get it to go in a straight line.  It seems to move just fine, but I can not move it in a straight line by moving the ball in a straight line.  It moves where I want it to, but it takes a lot of correction.  I only have it hooked up to a pc now to make sure it worked, so I have not messed with any setting in Mame, but I assume it should move like a mouse? Been along time since I used a trackball.




Nevermind, I got it.
clickhea:
i have this exact problem as well

it moves up and down fine

but left and right it sorta moves up and left  up and right

howd u fix it?
Turnarcades:
Usually because it needs bedding-in, is mounted at an angle or needs fine-tuning.
pupu:
I hate to admit this, but when I was mounting it, I mounted it even and square to the panel, when in fact it mounts with the "arrow" pointing straight up.  I did not notice the arrow till after I had it mounted in the panel.  I have to remount it now.  That was my problem, so was just my bad for not paying attention.
Navigation
Message Index

Go to full version