| Main > Main Forum |
| Any ideas on where to get wedge-based sockets for plugging lights/LEDs? |
| << < (2/2) |
| 1UP:
--- Quote from: BillyJack on June 13, 2003, 03:22:15 pm ---Are the wedge-based sockets that I linked from Happ controls not what you're looking for? --- End quote --- To reiterate from above: "I'm specifically looking for small square T 3-14 sockets with wire leads, not the thru-the-board screw-in types like Happ sells (too bulky for pushbuttons). " The ones Happ has are the round ones that screw into a hole on a circuit board, and are probably too big to fit into a happs pushbutton. I have seen smaller ones that are basically just a rectangular receptacle big enough for the wedge base to plug into. Whatever I use needs to be insulated, and no larger across than 1/2 inch to fit inside the spring. |
| BillyJack:
--- Quote from: 1UP on June 13, 2003, 10:44:13 pm --- --- Quote from: BillyJack on June 13, 2003, 03:22:15 pm ---Are the wedge-based sockets that I linked from Happ controls not what you're looking for? --- End quote --- To reiterate from above: "I'm specifically looking for small square T 3-14 sockets with wire leads, not the thru-the-board screw-in types like Happ sells (too bulky for pushbuttons). " The ones Happ has are the round ones that screw into a hole on a circuit board, and are probably too big to fit into a happs pushbutton. I have seen smaller ones that are basically just a rectangular receptacle big enough for the wedge base to plug into. Whatever I use needs to be insulated, and no larger across than 1/2 inch to fit inside the spring. --- End quote --- Sorry dude, it was early and I hadn't gotten enough coffee in the morning. BillyJack |
| 1UP:
Well, no luck at Home Depot. It's too expensive (and wasteful) to buy a whole malibu light for one socket... I'll try contacting one of the manufacturers to see if they sell direct, or if not, who does. Thanks |
| Navigation |
| Message Index |
| Previous page |