| Main > Main Forum |
| Removing gunk / adhesive on a metal panel to get it down to shinny silver |
| << < (2/4) > >> |
| pinballwizard79:
well that depends I have had 2 MAME arcades with metal control panels......its nice for trackball mounting for sure since no metal plate or routing will be required. anyway I bought HVAC sheet metal & used tin snips to make little backplates which I adhered with JB weld epoxy glue. after a day or two of curing I used jb weild putty to fill in the top......then I sanded it smooth, cant lie though....its better to put a little on at a time & do several fill, sand, fill, sand, fill & so on because if you just plow a bunch on there you will not enjoy sanding it smooth. regardless you will go through the process a few times to get it perfect & smooth, btw I have OCD so you may not need to go through that much trouble the best pic I have of my old metal CP is from my blackjack so excuse the PQ also, get that metal cp smooth & shiny so your primer will stick well sand a few coats of primer & use a hi gloss paint to coat, then your cpo decal will adhere nicely |
| mrclean:
I may or may not fill that extra hole in, like i said with a sheet of plexi on top it should be fine. Also the buttons that i drilled with a 1'' 1/8th drill bit seems to fit the leaf buttons I have but for whatever reason the holes that were on the taito cab looks like it has little tiny notches but don't seem to fit my buttons other then buying a dremel how can i trim the inside down? type of sand paper maybe ?? but again its metal |
| pinballwizard79:
I have not encountered that before, interesting issue |
| daywane:
lay a thin rag over it. soak it with WD-40 let sit. over night if need be glue should wash off. given enough time, WD - 40 will remove almost any glue. ask some of your friend that work at a factory. I have worked at a few of them... All have had some sort of sand blaster if you really want to het it new again. |
| shmokes:
--- Quote from: mrclean on September 19, 2008, 09:25:39 pm ---I have my first metal panel and i have since removed the control panel overlay, but beneath it was residue, i scapped it the best I could. Is there any way to get it down to the shinny metal/ smooth again? i remember a while ago seeing somewhere someone did a restore on a panel if any one has the link to that let me know. So do i use chemicals ? or what's the best easiest way to do this while I wait for my parts I have time. --- End quote --- Isn't your name mrclean? We should be asking you! |
| Navigation |
| Message Index |
| Next page |
| Previous page |