Arcade Collecting > Pinball
Indiana Jones Restoration..."Finished"
Visitor Q:
I guess I really didn't take notice that it was not completely done.
What's all left to do at this point?
Cyberflexx:
--- Quote from: koolmoecraig on January 25, 2009, 10:38:45 pm ---
I've saved all of my receipts basically treating this thing like a car restoration. I haven't sat down added it up but I figure it's probably close to $2000 in parts, clearcoating, brass plating and WAY too much time. The machine itself was $3000.
--- End quote ---
DAMN!!!! Are you going to play it when it's done or just look at it?
koolmoecraig:
--- Quote from: Visitor Q on February 03, 2009, 02:43:36 pm ---What's all left to do at this point?
--- End quote ---
I'm waiting for the side rails and wireforms to come back from being re-plated. I wasn't happy at all with the original plating job.
Once I get the side rails back and installed, I can put the back board on. Connect all the wires, get some playfield glass and I'll be good to go. Assuming I didn't muck anything up during the tear down and rebuild.
Visitor Q:
Wiring... Won't that be fun! :cry:
koolmoecraig:
--- Quote from: Visitor Q on February 04, 2009, 07:21:25 am ---Wiring... Won't that be fun! :cry:
--- End quote ---
Naaa, everything on the playfield is pretty much all connected. By wiring I meant putting the plugs back on the PCBs. I THINK I marked everything correctly so it should go smoothly.
For some reason my biggest concern right now is mounting the side rails. Ya get one shot and I fear im gonna muck it up.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version