Arcade Collecting > Restorations & repair
2600's Punch-Out Restoration
Spyridon:
--- Quote from: 2600 on September 08, 2008, 08:32:31 pm ---Well technically both since I'm finishing up the Double Punch-Out kit and will put the kit in here.
--- End quote ---
Another Punch-Out!! :applaud:
Are you going to be selling these kits? Now that Mikes Arcade is working on the SPO joystick, I'd love to be able to play both in my cab.
2600:
--- Quote from: MaximRecoil on September 08, 2008, 09:25:10 pm ---I've got one of the repro Ducking Pull stickers we did that I would consider a "factory second", due to the alignment of the carriage bolt holes being off enough to be a problem. The holes could be fixed with an exacto knife, and the carriage bolt heads would more than cover the amount that the holes are off by, so with the joystick installed, you couldn't tell the difference.
Considering the amount of help you provided in fixing the frustrating audio problem with my SPO boardset, I'll send you the sticker at no charge if you want it.
--- End quote ---
Maximrecoil, I think I'm going to take you up on that offer. I'll send you a PM later.
2600:
--- Quote from: Spyridon on September 08, 2008, 11:54:16 pm ---Another Punch-Out!! :applaud:
Are you going to be selling these kits? Now that Mikes Arcade is working on the SPO joystick, I'd love to be able to play both in my cab.
--- End quote ---
I will. I talked about it a little on KLOV. I don't think it will be that popular though, because it's a little pricey.
jow:
--- Quote from: 2600 on September 09, 2008, 05:55:12 am ---
I will. I talked about it a little on KLOV. I don't think it will be that popular though, because it's a little pricey.
--- End quote ---
Did we come up with a price? ;D
2600:
--- Quote from: jow on September 09, 2008, 10:21:06 am ---
--- Quote from: 2600 on September 09, 2008, 05:55:12 am ---
I will. I talked about it a little on KLOV. I don't think it will be that popular though, because it's a little pricey.
--- End quote ---
Did we come up with a price? ;D
--- End quote ---
I'm guesstimating $175. I don't want to go higher then that, but trying to go lower. I may offer kits of parts at a cheaper price. I'm also looking at other ways or offering options that would make it cheaper.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version