Main > Main Forum
U360 restrictor opinions
Ummon:
I'll have to look....eventually............I'm thinking if metal shafts don't work, then a washer underneath them (depending on which end meets which part - base or pcb) should.
AndyWarne:
--- Quote from: TheShanMan on September 07, 2008, 11:57:00 pm --- Maybe Andy doesn't think the more expensive octagonal restrictors would sell in that case though.
--- End quote ---
The octagonal restrictors we will probably never make any margin on, as they are a low-volume item and had the full cost of an injection mold to pay up-front. We had a mold made because we wanted to do it properly, using a chamfered hole rather than straight-cut, and using a very hard material. To be honest I think we went over the top, that stuff you could probably make train wheels out of and they wouldnt wear!
Andy