Main > Main Forum

Quick question about RGB LEDs

Pages: << < (2/2)

arzoo:


--- Quote from: gies77 on September 04, 2008, 05:59:01 pm ---Randy

Ok, I'll give that a shot tonight and see what happens.  I'll let you know how it works out.

Thanks again.

--- End quote ---

gies77,
Just a heads-up, Randy is GGG (the owner). I don't think he realized that you were using his preinstalled RGBs for ice buttons when he suggested you sand the tops down. Either something is not installed or wired correctly or something may be defective.

edit: I just re-read his post and I guess he does know that you're using the RGB-Drive boards. They should work correctly with the ICE buttons without any modifications.

gies77:

Just wanted to give an update.

I checked the LEDs and everything was seated properly so I gave the sanding a quick try and it worked out great and 15 minutes later I was back up and running, this time with no strange banding.

On a side note, Randy, any chance you will be offering the Clear RGB NovaGems as a regular item?  I would love to try a set of those out on my project.

Thanks all
G

Pages: << < (2/2)

Go to full version