| Main > Main Forum |
| Pop up spinner? |
| << < (2/3) > >> |
| kelemvor:
--- Quote from: GinsuVictim on September 03, 2008, 10:14:16 am ---3" is over-shooting it. --- End quote --- Well whatever, just depends how high you want it when fully raised and how low you want it when fully depressed... |
| DaOld Man:
You might make a bracket, mount one of those entertainment center door magnets on it. Mount the square piece of metal that usually attaches to the glass door to the bottom of the spinner. Press spinner once it retracts, press again and it pops up. of course you would need a spring on it too. |
| DaOld Man:
You could also make a slide device, but then you would have to have the handle or lever for the slide on your CP somewhere. |
| SavannahLion:
DaOld, the first idea likely wouldn't work if you wanted a Tron push/pull spinner. The second idea might work though. CaptainRhythm, can you tell us the depth inside your CP? It might give us a better idea of what the space limitations are. I have several ideas, but they all have varying degrees of complexity, cost, and space requirements. |
| Ummon:
That second idea would scare me. A lot of force against and friction underneath. However, if it were spring-loaded, and the slider was pronged such that it would lock the spinner in place when pushed down, and then also sit underneath it when released, that might work. Mounting would still be an issue. I'm sure a commercial enterprise could come up with a decent aftermarket device, but not for under a hundred dollars I'd bet. And it wouldn't be universal. |
| Navigation |
| Message Index |
| Next page |
| Previous page |