Main > Project Announcements
Console Joysticks in the Works. - NEW PHOTOS!! UPDATED 2/14/09!
Kaytrim:
--- Quote from: Gatsu on September 25, 2008, 10:44:23 pm ---I DEFINITELY need to find an easier way to mount the PCB. With as little room as their is in the case, I need to figure a way to glue it down or something....the tiny screws I found are unruly and just pull right out. No grip whatsoever.
:cheers: ;D ;D
--- End quote ---
Two words "Hot Glue" :cheers:
Gatsu:
ok. I thought that might work, but when I tried it, it didn't hold for crap. I'll give it another try on the next stick.
Kaytrim:
It might be the paint that caused the hot glue to not hold. I don't paint the inside of my cases so it holds just fine. You could scrape away a small area of the paint and then use the hot glue. Also put a good sized glob and have the board ready to press into the glue as soon as you remove the glue gun. Just hold it in place for about 30 seconds to a minute so the glue has a chance to cool.
Gatsu:
ah ok. I'll probably have to leave a section unpainted then.
thanks for the input. I'll probably make the next box a non-plexi bottom so I can get the board to stick easier.
HaRuMaN:
What controller did you hack for that?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version