Arcade Collecting > Restorations & repair
TheShanMan's Defender restoration - New repro wiring harnesses!!!
beerbarrel:
One more thing, I looked at my PS under a magnifying glass and just about all the solder pads that are around the connector pins and bad. You might want to take a close look at yours.
Tracy
TheShanMan:
I don't see any jumper. Everything looks kosher on the board except for the missing rectifier. I'll have a closer look, but on first glance the board appears to be in excellent condition.
beerbarrel:
I don't know that the jumper really matters. It just shorts across the 2 ohm resistor. My supply came out of a cock tail version. Looking at the schematic it shows a jumper and there is a note that says the jumper is not used on the CT version. Mine is there but it is cut in the middle.
Tracy
TheShanMan:
Interesting. I'll have to look at the schematic when I work on it. Sounds like you're saying it should have the jumper for the uprights. Thanks for raising the issue. BTW, I'd be interested in seeing a pic of yours, since as far as I could tell, there was no evidence of a jumper being on the board, and I'd like to see what it looks like, even if yours is cut. You could post it in your thread if you prefer since of course I'm following your restoration too. :)
beerbarrel:
Here ya go! My big cap is removed. Can you see the jumper?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version