Arcade Collecting > Restorations & repair
CHICKEN RESTORE LIKE A ROBOT (Berzerk) *IT LIVES*
shardian:
Ipac VE. $20 and 2 minutes of wiring = DONE. If you need to justify the money, skip lunch a few days and have cereal. ;D
ChadTower:
Ironically, I have an Ipac 4 sitting around, but don't want to use it. I think at this point I might just have to go with your suggestion.
I can't seem to ID the specific connector on the CP harness. Asked at KLOV, got a specific answer, but after googling the item it clearly isn't correct. I'm going to have to re-pin that connection and swap housings to something I do have. I ordered a whole variety of Molex .062 housings and an extractor tool last week, which would be perfect, but I'm a complete d-bag and forgot pins. :banghead: I do have some larger Amp Mate N Locks left over from the Tank II (which I really need to get back from the shop). It's overkill but it will do the job nicely.
I did sorta want the keyboard hack but the common ground wiring may be a blocking factor on that anyway.
EDIT: Bah. Ipac VE appears to be USB only. This is a dosmame setup.
SirPeale:
You're going to fix the Berzerk anyway, and the IPAC4 is just lying around. Use it and reuse it in another project when you fix the berzerk.
ChadTower:
--- Quote from: Peale on September 25, 2008, 12:40:02 pm ---You're going to fix the Berzerk anyway, and the IPAC4 is just lying around. Use it and reuse it in another project when you fix the berzerk.
--- End quote ---
I was just coming to that conclusion about an hour ago after I discovered the Ipac VE isn't dos compatible. At least it's incentive to get the boards fixed sooner than later.
ChadTower:
Replaced both CP harness connectors with new Amp Mate N Locks last night... new pins, too. Couldn't seem to get the pics off my wife's camera this morning, though, so I'll get a pic up tonight or tomorrow. Next up is whipping out the Ipac4 and wiring it up.
New CP harness connectors - both sides
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version