Main > Project Announcements

Bob's Arcade Cabinet 2nd attempt!

<< < (8/9) > >>

sayitaintjonas:

--- Quote from: BobtheAddict on April 27, 2009, 12:21:52 am ---My buddy gave me the idea of cutting the wire in 2 foot length and zip tying in place. This allowed me to keep the wire harness tight and allowing me to pull the slack out to hook up to the micro switch. Here are a couple of pictures of the wire in zip ties and hooked up to the micro switches.

--- End quote ---

Good advice! I'd say all that time spent on the wiring was well worth it. Looks great  :cheers:

BobtheAddict:
Thanks for the compliment sayitaintjonas, it is coming along slowly but it is getting there. I am afraid that if I do not spend the time on the wiring, something might go wrong and then I will have to fix it later on.

 I will post some new updated pictures tonight of the wiring job. I am 85% done and all that is left is to build a pinball plunger circit and wire up the side pinball buttons.

Ond:
I really like the fact that you've airbrushed your CP artwork, and you have a pinball plunger as well.  Very neat work.  I have zero experience  with an airbrush but that will be my choice too (when I reach that stage).

 :cheers:

BobtheAddict:
I finally got around to taking some additional pictures of the wiring. All that is left is ground a couple of buttons and wire up the pinball plunger.

Enjoy

BobtheAddict:
Wow,

I just looked at the last time I posted updates to my project and it has been more than three months. I do apologize, I ran into a difficult situation and needed a break to think about how I was going to over come the challenge.

In any event, I have finished up the wiring portion of the control panel and the next challenge is to build the pinball plunger circut. Here are some updated pictures of the insides on the panel itself. Although it took me over several months to complete, I am pretty happy with the end results.

Enjoy!

Navigation

[0] Message Index

[#] Next page

[*] Previous page