| Main > Main Forum |
| Can't find 7/8 light blue tmolding, should I use 1/16 plexi on CP? |
| (1/1) |
| Organic Jerk:
As the title suggests, I'm looking for light blue t-molding like this: http://www.t-molding.com/store/product.php?productid=65&cat=9&page=1 But at 7/8 for the CP (since the plexi is usuallt 1/8), which I can't seem to find. Has anyone ever used 1/16 plexi for the CP? Will it crack easier when drilling holes? Would a difference of 1/16 between them mean a difference in durability? Thanks |
| gatordad:
You could always route or sand the bottom edge of your cp, no one will ever know except you. ;D |
| javeryh:
yeah - put a 1/8" 45 degree bevel on the bottom and use 3/4" t-molding with your 1/8" plexiglass. It will actually look better if you are using 3/4" t-molding on the sides and stuff because everything will appear to be a uniform width. |
| Organic Jerk:
I dunno... I'm kinda scared to cut into the wood like that because I fear I will frack it up. The safer bet without cutting would be to use 1/16 plexiglass so that both the sides and the cp use 13/16 tmolding, but then 1/16 might be too thin to be of any use.... ARRGH. |
| Spaced Ace:
quarterarcade.com has 7/8 black. Can't you go with the 5/8 blue instead? I love your project, that cpo artwork is looking nice... |
| Navigation |
| Message Index |