| Main > Main Forum |
| dead zone on volume control |
| (1/1) |
| Breaker:
Hello all, I'm hoping some electronics gurus might be able to assist with a small issue I'm having with my volume control. I installed a remote volume control to my CAB's control panel using the method described at the old Oscar Controls website: http://mirrors.arcadecontrols.com/OscarControls/volume/index.shtml The potentiometer I used (100k as per the tutorial) has approximately 270 degrees of rotation and the volume jumps rather sharply in the first 10-15 degrees of rotation and again in the last 10-15 degrees but in between there is a rather large 'dead zone' where there is no effect on the CAB's volume. I did read that you could increase the sensitivity of potentiometers by adding resistors across the terminals, which I have tried, but this didn't have any effect. Do I need to use a different potentiometer (10K, 50K)? Have I possibly wired it incorrectly? I don't know if it's relevant but I'm using Logitech Z4 speakers. Any assistance would be greatly appreciated. Cheers, Breaker. |
| surface tension:
Howdy First of all, are you usig a linear pot instead of a logarithmic? You also say that you're putting a resistor across the terminals... It would need to be in-line with the wiper. So removing the wiper (usually center) wire and putting the resistor in series. Putting a resistor across the terminals will only decrease the resistance. |
| Breaker:
Hi ST, I'm using a logarithmic pot and, I should clarify that I'm not employing resistors, just gave them a try but they had no effect. I did put the resistor across the terminals so I could try putting them in series on the centre as per your suggestion terminal and see what happens but should this be necessary? I suspect folks will need additional info for troubleshooting so please ask away! Breaker. |
| Navigation |
| Message Index |