Main > Everything Else

LED PUSHBUTTON HELP !!!

(1/2) > >>

JohnnyD:
Hello fellow members,



I am building a Naomi 1 based Marvel VS Capcom 2 cabinet. I plan to use these LED pushbuttons I purchased off ultimarc.com. I was wondering on how I can run them on my set up? If I was going the Mame route, I would use the LED Wiz but for the Naomi, I'm quite unsure.


Thanks for reading!

Franco B:
What do you want to do with them, just light them? If so you just need to provide them with a 12v source. I dont know if there is a 12v point you can tap into from your system. If not you could just scavenge a PC PSU and take the power from one of the 12v yellow molex's.

Ginsu Victim:
Exactly what Franco said.

Have you seen my review of Ultralux pushbuttons from yesterday?

http://forum.arcadecontrols.com/index.php?topic=82468.0

Franco B:
After reading your review I see Ultimarc does a 5v version too, I had a quick look at the product page when I saw the OP post and for some reason I only saw the 12v info

If you are using the 5v versions either tap 5v from your system or use the red 5v from a PSU molex.

JohnnyD:
I have the 5 volt one actually :)

I'm trying to get it to run like this guy from here http://forum.arcadecontrols.com/index.php?topic=69968.200

I would like it to light up when activated, not have it run all the time.


--- Quote from: Franco B on July 21, 2008, 11:17:53 am ---After reading your review I see Ultimarc does a 5v version too, I had a quick look at the product page when I saw the OP post and for some reason I only saw the 12v info

If you are using the 5v versions either tap 5v from your system or use the red 5v from a PSU molex.

--- End quote ---

Navigation

[0] Message Index

[#] Next page

Go to full version