| Main > Main Forum |
| Request for Defender CP layout details |
| << < (6/11) > >> |
| TheShanMan:
--- Quote from: TOK on July 23, 2008, 05:48:59 am ---Mine sits pretty square. I just took a ruler and measured it (its tough because I have to estimate the center of the joystick shaft) and the button sits 1.5" right and 1.5" down of the stick. I noticed on the drawing, that for as good as it is, some of the measurements are tough to reference since its giving you numbers from the side of an original panel instead of in relation to each other. --- End quote --- I was thrown off by the joystick location - I thought that rectangle represented the shaft of the joystick, not the opening in the CP. :dizzy: So now that I understand that, I still don't come up with 45 degrees. I come up with 1.375" down and 1.75" to the right. TOK, it sounds like you wouldn't agree with that? Arzoo, can you confirm either my calculations from your post or TOK's measurements of 1.5" down and 1.5" to the right? |
| arzoo:
I agree - showing the panel slot rather than the location of the joystick shaft is confusing. I'll check my panel tonight. |
| TOK:
While my overlay is genuine, I'm using a Sanwa 8 way in the center of the oblong hole design used for Defenders 2 way. Since I'm not using a genuine stick, my stick setup might not be precise enough to judge by if you're looking for absolute accuracy. |
| arzoo:
Ok, on my cp, the joystick shaft on-center is 5.5" from the left and 2.5" from the top. That puts the reverse button 1.75" to the right and 1.25" below the joystick. |
| TheShanMan:
Thanks to both of you guys. Arzoo, your measurements are only a hair off of the measurements from that image you posted, and since you have the real deal, I'm going with your measurements. :) Not sure if I'll get around to making the mod soon (I'm going on vacation later this week), but I'll be sure to let you know how it turns out. |
| Navigation |
| Message Index |
| Next page |
| Previous page |