| Main > Main Forum |
| YDKJ Controller (was: Aw crud.) |
| << < (3/8) > >> |
| vertygo:
:laugh2: nice. |
| javeryh:
As much as it sucks, if I were you I'd recut the entire panel. If you are going to do it, do it right. :cheers: EDIT: just thought of something - can you cut a bezel out of really thin metal or wood? Something that would support all 4 buttons? Design a large curved bezel to fit around all 4 buttons, paint it black to match the artwork, drill 4 button holes and you are good to go. |
| Ginsu Victim:
What I was thinking. Whatever it takes to get the first button in, do it to the rest. |
| Namco:
Just glue a small scrap of plastic, about a few mm wide to the button cylinder on the threads up near the top, but under the lip. This will push the whole button assembly off center so that most of the lip will rest on the top panel. |
| Namco:
|
| Navigation |
| Message Index |
| Next page |
| Previous page |