Main > Main Forum

Drill bit for spinner?

Pages: (1/2) > >>

javeryh:

I have a slikstik tornado spinner and I'm about to drill the hole in my CP for the spinner shaft... what size drill bit should I use?

Jdurg:

I can't remember what size hole I drilled in my CP, but I do remember taking all of my spade bits and comparing the diameters with the diameter of the shaft of the spinner.  I ensured that the hole I drilled was bigger than the shaft so that if my screw holes weren't lined up right it wouldn't interfere.  Since the spinner itself covers a great deal of space, you can afford to make the hole a bit bigger than the spinner shaft itself.

javeryh:

I guess I'll just eyeball it by comparing my drill bits with the shaft of the spinner - I'll probably go 1/8" bigger than the shaft unless anyone chimes in...

Jakobud:

I clicked on this thinking that someone was gonna rig up a drill to their spinner for SUPER FAST TEMPEST ACTION!

 :banghead:

scotthh:

The Control Panel Hole Size Thread has been moved to the wiki. Both links have the answer to your question.


Pages: (1/2) > >>

Go to full version