| Main > Main Forum |
| U360 Balltop Spinning Off |
| << < (2/3) > >> |
| Ginsu Victim:
Never had this problem. On the bottom of the shaft there's a slot for a flat head screwdriver. Insert a screwdriver there and twist on the balltop tight. Shouldn't be an issue after that. |
| Kajoq:
Blue Loctite is the solution you're looking for. I had the same problem with my Sanwas |
| mrjah:
Another vote for Loctite. I like it better than thread tape for various reasons, although both can be perfectly appropriate for a variety of uses. Just don't accidentally use the permanent kind... |
| Havok:
Loctite is not the way to go - GinsuVictim said it. Just tighten it up with a flathead screwdriver, done. |
| Kajoq:
That doesn't always stay put. I did that numerous times to my sanwas (which I believe the u360 is somewhat based on) and they would still come undone. Put a drop of blue loctite and they're golden. And blue you can get off without breaking things. |
| Navigation |
| Message Index |
| Next page |
| Previous page |