The artwork is currently being tweaked. There is some small stuff to do on it before I get it printed but it isn't far away.
As for the bezel I am having a small problem with the measurements (see attached pic).
I need to get the measurements right for this part. As you can see the inside bezel section will sit inside the side section. Effectively the side will go up at 20 degrees and the monitor will sit at 30 degrees.
This means that with my calculations the speaker section will sit at 45 degrees meaning the sound will directly “face” the player. The other section is the bit that sits below the marquee.
In this case the angles are key as well as the 682.8mm height (or 683mm to make it easier. The speaker section does not really need to be 130mm but it should be the minimum if possible to accommodate 4” speakers.
Could anyone draw this up in Autocad and give me the correct dimensions?
Hopefully when this is fully completed I can get some help drawing this up (or doing a render) in Sketch up to see how the cabinet looks as I have no clue when it comes to using it!!!
Also, Franco has very kindly helped with creating the dimensions for the cab. They are also attached. Thanks again Franco!!!