Main > Main Forum

T-Molding Question

Pages: (1/1)

jholman76:

I'm building a cabinet and had a question about T-Molding.

When I put it in on the sides, I am starting on the back side and going all the way around to the front. My question is should I do the underside, where it sits on the ground, too? Would that be helpful to protect the plywood (im doing a furni-cab) from chipping? Or should I stick with rubber feet?

K Thx Bye

Joe

Level42:

Depends on the cab, but you can't use T-molding to let the cab rest on. It's not suitable to carry the weight, if you move the cab, it could very well get damaged or loose at least.

jholman76:

Ok, that is what I was questioning.. I have some rubber feet I will use on the bottom. I still plan on t-molding the back, top and front, just not the bottom..

Thanks!

Joe

Ginsu Victim:

Install leg levelers or wheels. Don't just let your cab sit on the floor.

As for the t-molding, it looks better (IMHO) to have it on bottom. I started in bottom middle, and worked it around until the ends met.

Pages: (1/1)

Go to full version