Main > Main Forum
Announcing U-HID, a new generation of control interface.
<< < (7/9) > >>
AndyWarne:
The config does save the calibration settings.

Actually it doesnt really matter if you leave analog inputs disconnected, they tend to float high, and then also if they are not configured as any control in the game it would not matter if they did change or would it?

The board can only store one configuration, the rest of the flash is allocated for a large macro capability. But downloading a different config is instant and could be done with a command line and probably tied to a hotkey using a third-party keymap utility.

Andy

Paul Olson:
I ordered the U-HID last night, so hopefully I will be testing it out in the next few days. How many people are planning to use this for modular or swappable panels? I think I will be able to cut down on the rat's nest of wiring by a huge margin. I hate to tear into a working system and start over, but this may well be worth the effort.

I'll post back after I get it up and running.

Andy - I plan to use ide cables to wire this to the patch panel on my cp. Is there room for this on the smaller section? It looks like the cap may get in the way on that side, but it should be OK to let it overhang on the other side. Am I right on this?

I haven't found an ide cable laying around yet, so I will ask here. Will this cable work with a 110 type patch panel?

Thanks,
Paul
Kremmit:
Hey, that's a neat toy you've got there, Andy!  :applaud:

Would it be possible to have the board appear to Windows as two separate gamepad devices with at least 4 axes each?  I'm thinking of two-player dual-analog stick control here.

Also, is there or will there be any way to hook some U-360's to one of these?  I've been wanting a way to make two U-360's appear to Windows as one single dual-analog gamepad.
Xiaou2:

 Flash for the Config store?   :(    As much as Ive heard that Flash only
can take so many re-writes before it gets corrupted and no longer functions
correctly.

 Why not  Ram instead?
AndyWarne:

--- Quote from: pcolson on May 26, 2008, 02:24:58 pm ---
Andy - I plan to use ide cables to wire this to the patch panel on my cp. Is there room for this on the smaller section? It looks like the cap may get in the way on that side, but it should be OK to let it overhang on the other side. Am I right on this?

/quote]
It would hit the cap, but you can offset it to the left. Looks a bit naff but should work. Beware of the missing pin in IDE cables though.
Andy
--- End quote ---
Navigation
Message Index
Next page
Previous page

Go to full version