Main > Main Forum
Adding a coin door, how to cut my existing cab and is this happs part all i need
<< < (2/2)
javeryh:
There is a ton of play with these doors.  Just plot the measurements of the cutout on your panel and use a jigsaw to cut it out as close to the line as possible.  Any imperfections in your cut will be hidden by the lip around the edge of the coin door.  As for wiring, there are two microswitches which you can run in parallel to the coin buttons that you already have on your CP.
mrclean:
All my buttons are already daisy chained to eachother the top two metal pieces where the quick disconnects go into one i think is ground, the other is source.. whats the third / unused one for? Also any way i can do this off my U360 stick ??
Navigation
Message Index
Previous page

Go to full version