Main > Main Forum
Getting a custom cut plexi for CPO with holes etc, *DONE* pics attached
(1/5) > >>
mrclean:
I'm looking to see if anyone offers a service for a custom cut CPO plexi, I want to preserve my artwork underneath. Also what's the best way to secure this? can i simply use the buttons and twist the nuts underneath to secure the plexi to the Control panel ? What would something like this cost? the size is aprx 23.5''w X 11 1/4 h
leapinlew:

--- Quote from: mrclean on May 19, 2008, 07:07:59 pm ---I'm looking to see if anyone offers a service for a custom cut CPO plexi, I want to preserve my artwork underneath. Also what's the best way to secure this? can i simply use the buttons and twist the nuts underneath to secure the plexi to the Control panel ? What would something like this cost? the size is aprx 23.5''w X 11 1/4 h

--- End quote ---

1 MEEELION DOLLARS!

I have no idea, most of us do our own.  ;)
vitalsfading:
it would be nice to find someone on the board that has a cnc mill to do that kind  of work
mrclean:


--- Quote ---1 MEEELION DOLLARS!

I have no idea, most of us do our own.  ;)

--- End quote ---

that sounds like a stinky deal!
 
Ian:
Actually I got my Plexi cut by ACE hardware for free... All I had to do was pay for the Plexi! What I did was give them the CP with the holes drilled in and then told them I wanted the plexi to match... they did it for me in a couple of days... not bad work either, a few chips here and there, but overall it was better than me screwing around with it.
Navigation
Message Index
Next page

Go to full version