Main > Main Forum
How many feet of t-molding for a Lusid cabinet?
<< < (2/2)
solowCX:
Was hoping to get it ordered before the cabinet was built, thus asking now. It sounds like 45 feet would probably be more than fine, but might bump it to 50 just to make absolutely sure due to variances in control panel size, etc. Thanks for the help everyone, even Havok  ;)
jhabers:
I just built one and I ordered 2 - 20 lengths. 1 for each side and I had a few feet left over for each side (not enough for the CP). I ordered another 20ft for the CP. The place where I got the t-molding from only came in 20ft sections. but 20ft for each side is more than enough
Dmod:
Two 20' reels is enough to fully cover the sides (including bottom).  You'll need another 10' or so to cover the control panel.
jhabers:

--- Quote from: jhabers on May 18, 2008, 12:29:59 pm ---I just built one and I ordered 2 - 20 lengths. 1 for each side and I had a few feet left over for each side (not enough for the CP). I ordered another 20ft for the CP. The place where I got the t-molding from only came in 20ft sections. but 20ft for each side is more than enough

--- End quote ---

I just checked my scrap t molding and i had 4' left over per side, so ~16' per side, to wrap all the way around from the bottom of the CP to the top of the CP
Navigation
Message Index
Previous page

Go to full version