Main > Main Forum
turbo out run gearshift turbo button question and some board
Pages: (1/1)
G1zm0:
I got a TURBO OUTRUN cab in need of repair (cosmetic) anyway the hi/low gearshift turbo button is only activated when it says overheating and you put shift to high.
I looked in back at the wiring but the turbo button i presume is ground and signal wires, one (ground ) is connected to microswitch ground(thats used for hi low) and the other is twisted on to a blue wire thats connected to a molex connector.
What should this wire be connected to so it works independent of the shift hi mswitch?
G1zm0:
any ideas?
protokatie:
The guy who owns the laundrymat next to where I work has a Turbo Outrun there. I will ask him to email the people he leases the games off of about it. (Assuming noone else replies with relevant info). This could take a week, as I dont run into the guy but every few days...
G1zm0:
ok thanx, its just to see where the turbo utton is connected to, even if he takes a snap of where it goes
thanx
scotthh:
Here's the Turbo Outrun Upgrade manual.
I found it here and here. I hope it helps.
Pages: (1/1)