| Main > Main Forum |
| turbo out run gearshift turbo button question and some board |
| (1/1) |
| G1zm0:
I got a TURBO OUTRUN cab in need of repair (cosmetic) anyway the hi/low gearshift turbo button is only activated when it says overheating and you put shift to high. I looked in back at the wiring but the turbo button i presume is ground and signal wires, one (ground ) is connected to microswitch ground(thats used for hi low) and the other is twisted on to a blue wire thats connected to a molex connector. What should this wire be connected to so it works independent of the shift hi mswitch? |
| G1zm0:
any ideas? |
| protokatie:
The guy who owns the laundrymat next to where I work has a Turbo Outrun there. I will ask him to email the people he leases the games off of about it. (Assuming noone else replies with relevant info). This could take a week, as I dont run into the guy but every few days... |
| G1zm0:
ok thanx, its just to see where the turbo utton is connected to, even if he takes a snap of where it goes thanx |
| scotthh:
Here's the Turbo Outrun Upgrade manual. I found it here and here. I hope it helps. |
| Navigation |
| Message Index |