| Main > Main Forum |
| Power On issue - One button Start |
| << < (9/10) > >> |
| thatitalian:
OK, this is how my board looks like. I know, the quality is poor, my camera is rubbish! So you just wired it up to the microswitch on the pushbutton as normal. That I can do! My only concern is just soldering the wires to the correct part of the PCB. Anyone reckon they could figure out where this is? I reckon the power is the one circled in red below and the ground is the one circled in green. o o o o o o o o o o o o o o o This is my diagram (kinda) of the solder bits at the bottom of the PCB, the one where the ribbon cable connects to. |
| thatitalian:
:dunno |
| thatitalian:
Any takers? You know I will get a reply when I say "well I did it, and it went wrong" lol. |
| Zobeid:
--- Quote from: thatitalian on May 13, 2008, 09:19:46 am ---Any takers? You know I will get a reply when I say "well I did it, and it went wrong" lol. --- End quote --- In an earlier message I did suggest soldering directly to the legs of the tiny pushbutton. That would still be the most straightforward thing. Not sure what else you need that hasn't been covered. |
| thatitalian:
The only problem is what part of the legs? 2 wires (ground and the other one), 4 legs! Excuse me if I sound like an idiot, my wiring is only as good as fitting plugs! I'm not bad with a jig though..... |
| Navigation |
| Message Index |
| Next page |
| Previous page |