| Main > Main Forum |
| What size hole saw needed to drill for cp buttons? |
| (1/2) > >> |
| nick-g:
I am looking to add a piece of plexi over my control panel. What size hole saw will I need to drill the holes for normal arcade buttons? How about for joysticks? |
| u_rebelscum:
1 1/8" Depending on if you bottom mounted, routed bottom mount, or top mount: 1 1/4", depends on how much you routed, and 1 1/8", respectively. (Assuming normal throw happs like joystick; other sticks might need more or less.) |
| The_Tyler_Black:
I perfer to use a 1/8th paddle bit. it makes it easier if your doing alot of holes! |
| solderguy1:
And start by drilling the backside out 1/3 of the way or so, then switch to the front and finish. It keeps the hole smoother. |
| Vash:
--- Quote from: solderguy1 on April 25, 2008, 08:36:25 pm ---And start by drilling the backside out 1/3 of the way or so, then switch to the front and finish. It keeps the hole smoother. --- End quote --- How do you make sure that it lines up on both sides? |
| Navigation |
| Message Index |
| Next page |