| Main > Main Forum |
| U360 Shift Function PROBLEM |
| (1/1) |
| koolmoecraig:
I have my U360 updated to the latest firmware(2.4) which is supposed to have shift functionality. I am having a weird problem. Button #8(Violet Wire) on the U360 button harness is supposed to trigger shift mode when held down. In Windows while doing a button test, the button I have hooked up to the #8 Violet wire shows up as it should as button #8. When I am in Mame trying to configure buttons, that same button is showing up as Button #7. Therefore I obviously cannot use the shift function. Anyone have any idea what would cause this??????? |
| Ginsu Victim:
Test the other wires by touching them to the ground wire and see which one shows up as button 8. It could just be a wiring error on the manufacturer's part. |
| destructor:
In Windows bottons are numbered 1-8, in MAME 0-7. |
| Ginsu Victim:
^That is true. |
| koolmoecraig:
--- Quote from: destructor on April 25, 2008, 02:30:51 am ---In Windows bottons are numbered 1-8, in MAME 0-7. --- End quote --- Good call. Thanks. |
| Navigation |
| Message Index |