Main > Project Announcements
Ms Pac-man is ALIVE with NO HUM BAR.... HOORAY
Lutus:
Alrighty dimensions time peeps!
I included pictures just so you can confirm this is the dimensions you wanted.
Marquee inset dimensions: 1" exactly (not including T-molding)
Control panel top: little under 7" hard to say since it is curved
Control panel front: 3 and 3/4" curved, but easier to tell
Kick panel inset: 1/3"
Did you want the control panel dimensions or the piece of wood that the control panel sits on?
spacies:
You are a legend!!!! And with photos!!!
Thats awesome, awesome, awesome.
Thats all I need. Oh, what piece of wood does the CP sit on? Is it the one that runs side to side which also supports the plexi?
Jdurg:
A classic is saved! :applaud: :cheers:
Lutus:
--- Quote from: spacies on April 22, 2008, 11:36:21 pm ---You are a legend!!!! And with photos!!!
Thats awesome, awesome, awesome.
Thats all I need. Oh, what piece of wood does the CP sit on? Is it the one that runs side to side which also supports the plexi?
--- End quote ---
Back in ten minutes with photos.... hang on
Lutus:
OK, so interesting design so that the control panel covers a portion of the bezel.
On to the show...
First pic shows that the control panel rests on the two metal wings on the left and right side, on the front of the cab itself (wood) and rests/covers about an inch of the bezel.
Second pic attempts to show a side view of the wood that holds the bezel in. There is a thin lip built into the piece of wood so the bezel doesn't slide forward
Third pic, painter's tape marks the top of the CPO when installed and the last pic shows the overlap amount of the control panel.
Hope that makes sense. :cheers:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version