| Main > Main Forum |
| Help! Donkey Kong 4 board to 2 board pcb swap? |
| << < (2/2) |
| WunderCade:
Not sure about using a 4-board with a 2-board edge connector but you would need the extra "7P SOU" cables for the four board config. |
| Bender:
The sound seem to have a tiny bit of distortion or maybe it's just a little louder? The other thing I noticed is that the screen is crisper a very nice bonus I wasn't expecting! The "Brightness" adjustment is different too with the 4 board set jut the brightness pot would get a very light screen background and now I have to use the "Screen" adjustment as well. works fine just curious.(I lighten the screen to center the image) yeah it took all of five minutes to swap it out |
| pcb:
On DK, there is an adjustment for the volume of all the Digital sounds. We usually turn that pot up full. You may wan to turn it down just a tad. It could also be a bad cap in the output circuit if it's distorted. The volume adjustment for the digital sounds is just under and to the right of the edge connector. |
| Bender:
--- Quote from: pcb on March 23, 2008, 01:56:28 pm ---On DK, there is an adjustment for the volume of all the Digital sounds. We usually turn that pot up full. You may wan to turn it down just a tad. It could also be a bad cap in the output circuit if it's distorted. The volume adjustment for the digital sounds is just under and to the right of the edge connector. --- End quote --- Thanks Mike! :cheers: turning that pot down a little seemed to fix the problem |
| Navigation |
| Message Index |
| Previous page |