Main > Main Forum
Adding LED's to coin return buttons
<< < (4/7) > >>
TazMan:
The size I used was T 3 1/4 wedge base.
I thought I remember seeing the Happ's price being like over $10.00 / bulb or something like that...  I checked - I guess if you are going to use Red, the price isn't that bad $3.20; but, the white ones are $14.25.
Frostillicus:
10 bucks? An LED from superbrightled's is like 2 bucks tops, add a cheap radiocrap resistor..talking 3 bucks at the most.  
TazMan:

--- Quote from: Frostillicus on May 26, 2003, 11:57:13 pm ---10 bucks? An LED from superbrightled's is like 2 bucks tops, add a cheap radiocrap resistor..talking 3 bucks at the most.  

--- End quote ---

I agree "Oh Frosti One"  actually the ones I mentioned near the start of this thread have the limiting resistor built-in- and are less than $3.00  :o
Frostillicus:
Ah - didn't see that one.  good call.  Those wedge's are a better solution for folks who don't want to figure out the resistor value, too  ;)
crashdmj:
How do you think the red wedge offered by happs would look for the red coin return button's? I mean would it lite it up enough you think?
Derek
Navigation
Message Index
Next page
Previous page

Go to full version