Main > Main Forum

Calling Ms Pac/Galaga owners *3 simple measurements needed pls*

Pages: << < (5/16) > >>

spacies:


--- Quote from: coltchillin on March 24, 2008, 01:43:44 pm ---i guess ordering the side art from twobits would solve the panel shape problem :)


--- End quote ---

So does their art come pre-cut?

patrickl:


--- Quote from: spacies on March 24, 2008, 03:55:00 pm ---
--- Quote from: coltchillin on March 24, 2008, 01:43:44 pm ---i guess ordering the side art from twobits would solve the panel shape problem :)


--- End quote ---

So does their art come pre-cut?

--- End quote ---
If you look at the picture you can see where the artwork is and where it's painted blue.

I would assume it's pre-cut, but oversized.

spacies:

Yeah I see that.

I was blinded by that 'thing' it is stuck too.  :laugh2:

I am going to use Joymonkeys drawing above I think.

coltchillin:


--- Quote from: spacies on March 24, 2008, 04:11:12 pm ---...I am going to use Joymonkeys drawing above I think.

--- End quote ---

you got it in .ai or something?


spacies:


--- Quote from: coltchillin on March 24, 2008, 05:44:28 pm ---
--- Quote from: spacies on March 24, 2008, 04:11:12 pm ---...I am going to use Joymonkeys drawing above I think.

--- End quote ---

you got it in .ai or something?


--- End quote ---

Yeah I do.
I created a new project with the correct horizontal and vertical size, inserted joymonkeys pic and stretched it to fit.
I have done this with every other good photo I could find so now I have 6 layers. When I flick through them or make them transparent they all line up with very slight differences in the art work which I suspect is from the factory.

I printed a full size cab out and this is what I came up with.



That is lying on my artwork.

This confirms I have the sizes right:



The MDF on the right is cut to Jakobuds specs:



This confirms those plans are wrong:



I am fairly happy now.
A bit more tweaking and I am ready to build.



Pages: << < (5/16) > >>

Go to full version