Main > Main Forum

Calling Ms Pac/Galaga owners *3 simple measurements needed pls*

Pages: (1/16) > >>

spacies:

G'day guys.

I am wanting a high res photo of the side of one of these cabs.

Seeing there is no correct plans on the interweb, I think I will just print out the complete side and use it as a template. I know the correct height and width so I will just scale the photo to that.

Can anyone help please? I am looking for a direct side-on photo.

Thanks in advance.
Spacies.

Neilyboy:

I can take a pic if no-one else can. but I thought I saw a project in project announcements of a guy who was building one from scratch who had some dead on measurements. Anyway Ill snag a good side shot for  ya if you need it.

Neil

spacies:

Thanks,

I didn't see the thread in the PA. Can you remember who it is?
I can't find it.

 :cheers:

patrickl:

I'd love an accurate side view too.

I corrected Jakobuds side plan from the side picture I found on this page. For the life of me I don't know where I left this drawing though. The picture is slightly distorted and Wade says that the slope on the front under the CP shouldn't be there.

If fixed the image a bit, but it's still pretty low res:


spacies:

Patrickl, funnily enough I just resized and cropped that very same pic in Illustrator.
I downloaded 3 others as well and resized and layered them in Illustrator. Then I changed the transparency to see the layers below and the all matched except for small differences in the side art which I suspect was a problem out of the factory.

A good photo of a cabinet nice condition would be very helpful. Preferably a Ms Pac because it would be easier to see the outline rather than the black of a Galaga.

Ok, pic time. Who's gonna help us out?

Pages: (1/16) > >>

Go to full version