| Main > Main Forum |
| Calling Ms Pac/Galaga owners *3 simple measurements needed pls* |
| (1/16) > >> |
| spacies:
G'day guys. I am wanting a high res photo of the side of one of these cabs. Seeing there is no correct plans on the interweb, I think I will just print out the complete side and use it as a template. I know the correct height and width so I will just scale the photo to that. Can anyone help please? I am looking for a direct side-on photo. Thanks in advance. Spacies. |
| Neilyboy:
I can take a pic if no-one else can. but I thought I saw a project in project announcements of a guy who was building one from scratch who had some dead on measurements. Anyway Ill snag a good side shot for ya if you need it. Neil |
| spacies:
Thanks, I didn't see the thread in the PA. Can you remember who it is? I can't find it. :cheers: |
| patrickl:
I'd love an accurate side view too. I corrected Jakobuds side plan from the side picture I found on this page. For the life of me I don't know where I left this drawing though. The picture is slightly distorted and Wade says that the slope on the front under the CP shouldn't be there. If fixed the image a bit, but it's still pretty low res: |
| spacies:
Patrickl, funnily enough I just resized and cropped that very same pic in Illustrator. I downloaded 3 others as well and resized and layered them in Illustrator. Then I changed the transparency to see the layers below and the all matched except for small differences in the side art which I suspect was a problem out of the factory. A good photo of a cabinet nice condition would be very helpful. Preferably a Ms Pac because it would be easier to see the outline rather than the black of a Galaga. Ok, pic time. Who's gonna help us out? |
| Navigation |
| Message Index |
| Next page |