Main > Main Forum
Before I order....question about crimp connectors
(1/3) > >>
jhabers:
Have my cart ready to order but not 100% sure these are the right size. I have HAPP Buttons, Ultimarc Ultralux buttons and Ultra Stick Joysticks, I only have the ultimarc buttons and joystick in front of me and when I measure the terminals on them I measure them as .25". I read on this board to get .187 connectors. From looking at the numbers they don't seem like the right size, am I missing something? This is what I have in my cart

http://www.jammaboards.com/store/187-quick-disconnect-terminal/prod_87.html

along with this wire.

http://www.jammaboards.com/store/hookup-wire-blue/prod_52.html

will the quick disconnects fit the terminals, and will the terminals fit the wire....properly....


Thanks!

Jon
sarge:
If the lugs on your switches are .25 inch then you need to buy connectors that are .25 inch.  22 gauge wire will work fine with these connectors. 
pincky:
The Light outputs are quick disconnect .25" and  everything else is .187"

try the real bob roberts hes got come great prices on quick connectors

here is the link
http://www.therealbobroberts.net/qd-id.html

there where i got mine from
vince
rrcade:
Make sure you get a GOOD crimp tool. Bob sells them cheap
pincky:
on that subject

radio shack also sells a crimping tools that is just used for crimping

I have it its a really great tool

it has three slots colored

RED

BLUE

Yellow

for different sizes
Navigation
Message Index
Next page

Go to full version