| Main > Main Forum |
| Dremcast controller hack |
| << < (4/7) > >> |
| LoyalistRevolt:
Wow thanks you were a lot of help...anyway do I still need an I-pac for this? Also could tin wire work? |
| HaRuMaN:
--- Quote from: Kaytrim on March 05, 2008, 12:19:51 am ---Using an exacto knife will do the job. Just don't be too rough, you want to leave the coper on the pad. --- End quote --- This is why I use a dremel + wire wheel at the lowest speed + light pressure. |
| Kaytrim:
--- Quote from: LoyalistRevolt on March 05, 2008, 07:34:50 am ---Wow thanks you were a lot of help...anyway do I still need an I-pac for this? Also could tin wire work? --- End quote --- If you are doing this for a dreamcast console only then no you don't need an I-Pac. If you are building a control panel for a MAME machine then you will need an I-Pac, GP-Wiz or Key-Wiz to interface with the computer. As long as the wire you use will hold solder then it should work. TTFN Kaytrim |
| LoyalistRevolt:
Ok I think I got it all I need to do it strip the controller to copper....then solder all the wires to there spot....then, connect them to the buttons and your done? |
| LoyalistRevolt:
Sorry for double posting but after I got all the material I pretty much knew what to do I just have a quick question is there anyway to check if your doing it right as you go? |
| Navigation |
| Message Index |
| Next page |
| Previous page |