Main > Main Forum

Cutting the bezzle

Pages: (1/1)

gamecaptor:

I just bought a new bezzle for my arcade cabinet, but I need to cut it down to fit. What should I use so it makes a clean, solid cut?

paigeoliver:

What is a bezzle?  ;D Is that like a bezel? If it is, then I have cut mine with a box cutting knife before.

AlanS17:

Just score it really well with a utility knife (box cutter). You don't even have to go all the way through it. You don't have to saw it.

When you get a really good deep line you can actually rip it in a straight line.

gamecaptor:

Cool, thanks for the advice. O-and yes, I meant BEZEL :)

Brad Lee:

Assuming it's plexiglass, this is what Ive done for long straight cuts

I usually tape off the straight line on the "good side" jsut to make sure that when Im cutting it stays straight. I've got 2 long metal straight edges, so I keep one right along the taped edge and repeatedly score it with either a razor blade widget thingy, or Ive got a regular plexi cutting blade(usualloy hanging right next to where you find the plexi) When it seems deep enough I square up the cutline right over the edge of a table or bench, still applying pressure on the straight edge, I then take the other one which is really a beam level(so its nice n sturdy) butt it right up to the edge of the other SE, at this point its hanging over the table and resting on the "scrap" piece.  Give it a good WHACK with a rubber mallet/coated ballpeen hammer right in the center of the level and it just snaps nice n clean. This works good on thin cuts- plexi usually comes in 24" width, but the size I need is about 23-1/2" SO theres not a lot of scrap to get a good hold on
If small pieces are left attached to the good side, I use a good clean pair of pliers, line it right up to where the cut should be and just apply a little downward pressure. 99% of the time it follows the score line and leaves it nice n smooth

Pages: (1/1)

Go to full version