Main > Main Forum

Spinner what Axis?

Pages: (1/1)

bent98:

I have a TT2 spinner and a Happ USB 3 inch trackball. Just wondering if I should put it on the x,y, or Z axis? Is there any advantage or disadvantge to putting spinner  on Z axis? Also if I did put it on the Z Axis, which controls setting in Mame do I change?

fixedpigs:

sometimes backspin will be a problem on the z axis...it was for me and at least one other guy...
i put it on the x axis and it was good to go...

if you put it on the y axis...then you could use it to scroll through your gamelist on mala...


bent98:

No conflict with it sharing same as trackball?

Encryptor:

Maybe reading this thread will help you figure out which one to use.

http://forum.arcadecontrols.com/index.php?topic=75693.0

Encryptor

RandyT:


--- Quote from: bent98 on February 28, 2008, 09:21:17 pm ---No conflict with it sharing same as trackball?

--- End quote ---

Not if the trackball is on a physically different interface board.  But they cannot both be connected to the same board and axis.

RandyT

Pages: (1/1)

Go to full version